You can use this command instead to skip the Settings app altogether and just show the Wi-fi fly-out pane where you can connect more quickly: You can press Shift-F10 to open a command prompt (as long as the device is not running in S Mode), and from there you can launch the Settings app by running the command:Īnd after the Settings app loads, you can navigate to the networking Wi-fi page, connect, and continue from there.īut there’s a slightly easier way. But, if you are still not sure, it is always good to take the advice of an expert who can solve the problem for you effectively.As part of our Windows Autopilot white glove documentation, we state that Ethernet connectivity is required “due to the requirement to choose a language, locale, and keyboard to make that Wi-fi connection doing that in a pre-provisioning process could prevent the user from choosing their own language, locale, and keyboard when they receive the device.”īut as a number of you have pointed out, it isn’t that hard to make a Wi-fi connection during OOBE. So, these are some of the methods which can help you to see all the connected network devices in the explorer. Now, in the GENERAL tab, make sure that the ‘ startup selection’ is checked to normal startup. If the above-mentioned default settings are not present, then go to the “system utility” by clicking on Start and then type MSCONFIG. Confirm that the above settings are set to default as mentioned above.You will see the computer browser services there.Click on Start and type “services.msc”.To check the computer browser services follow the steps: The default setting of the computer settings is the Manual (Trigger Start) and the status is “running”. Though this is quite rare, you can check this if the above methods do not work for you. There are chances that the computer browser system you are using is not enabled. Here also you will have the option to change the name of the workgroup.Confirm workgroup in the computer name tab.On the left side click on the advanced system settings.Right click on my computer and click on properties.If the workgroup is not same, you can click on change button in the lower right corner to change the name. Make sure that each computer on the network has the same workgroup as the other.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |